The cirros image was rebuilt against the 3.13.0-83 kernel, drivers e1000e, igbvf...

[packages/trusty/cirros-testvm.git] / cirros-testvm / src-cirros / buildroot-2015.05 / board / ts / ts5x00 / readme.txt

diff --git a/cirros-testvm/src-cirros/buildroot-2015.05/board/ts/ts5x00/readme.txt b/cirros-testvm/src-cirros/buildroot-2015.05/board/ts/ts5x00/readme.txt
new file mode 100644 (file)
index 0000000..1e50682
--- /dev/null
+++ b/cirros-testvm/src-cirros/buildroot-2015.05/board/ts/ts5x00/readme.txt
@@ -0,0 +1,52 @@
+Technologic Systems TS-5x00 SBCs
+================================
+
+This document explains how to set up a basic Buildroot system for the
+Technologic Systems TS-5x00 serie of x86-based Single Board Computers.
+
+TS-5x00 Single Board Computers are based on the AMD Elan520 processor. For more
+information please have a look at http://wiki.embeddedarm.com/wiki/#AMD
+
+The kernel configuration works for any AMD Elan520-based SBCs, but the support
+is enhanced for the TS-5500 and TS-5400 models (on-board devices registration
+and additional sysfs attributes under /sys/devices/platform/).
+
+To build the default configuration you only have to:
+
+    $ make ts5x00_defconfig
+    $ make
+
+You will need a Compact Flash card of sufficient size and the first or only
+partition configured as Linux type, with the bootable flag.
+
+You can transfer the system on the partition then optionally resize it with:
+
+    # dd if=output/images/rootfs.ext4 of=/dev/sdX1
+    # resize2fs /dev/sdX1
+
+Or you can just extract the root filesystem to the partition with:
+
+    # mount /dev/sdX1 /mnt
+    # tar -pxf output/images/rootfs.tar -C /mnt
+    # umount /mnt
+
+To install the bootloader, you will need to copy the MBR:
+
+    # cat output/images/syslinux/mbr.bin > /dev/sdX
+
+Then install SYSLINUX in the mounted partition:
+
+    # mount /dev/sdX1 /mnt
+    # output/host/sbin/extlinux --install /mnt/boot/syslinux
+    # umount /mnt
+
+IMPORTANT: In order for the board to boot the Compact Flash with a recent
+config, the BIOS must use Logical Block Addressing (LBA). You can do it by
+choosing "Ide 0: AUTOCONFIG, LBA" under "IDE DRIVE GEOMETRY" in the "Basic CMOS
+Configuration" screen. Also, don't forget to set the 'active' (or 'bootable')
+flag on partition 1. For details about the CMOS setup, please see:
+http://wiki.embeddedarm.com/wiki/TS-5500#System_BIOS_Setup_Screens
+
+Connect a terminal program to the rs232 connector marked "COM2"
+with baudrate set to 115200, insert the Compact Flash card into the socket,
+power up the board, and enjoy.